•Suitable for horizontal grooving, and X positioning processing.
•Using hydraulic cylinder on X-axle for DY-2500HY and feed is by manually on Y-axle.
•All casting is finished through annealing stress with M casting iron; the slides for X, Y, Z-axle are handled by heating and grinding; the sliding for X, Y-axle is light and clever without abrasion because of pasting anti-abrasion pieces. We use C5 level for X, Y-axle, pre-pressed nut of ball screws, which is to press smoothly and position well due to small gap. Using the timing oil-filling on X, Y, Z-axle and nut to ensure the precision for each section.
•The table adopts dovetail type, double-sided pins, saddle width 1250mm, and the contact surface with the table is increased.
•The base is bed type, which has higher processing stability compared with the knee type, and the column is widened to enhance rigidity and toughness.
|
MODEL |
2500HY |
|
TABLE |
|
|
Working surface of table |
1500x352mm |
|
Longitudinal travel |
600-1200mm |
|
Cross travel |
350mm |
|
Vertical travel |
390mm |
|
T-slots (size x number x distance) |
18mx3x70mm |
|
Range of longitudinal feeds (mm/min) |
Manul |
|
Rapid longitudinal traverse (mm/min) |
2300mm/min |
|
Rapid vertical traverse |
500mm/min |
|
HORIZONTAL SPINDLE |
|
|
Range of spindle speeds (6set teps) |
60Hz: 86-915 R.P.M 50Hz: 72-763 R.P.M |
|
Taper of spindle nose |
NST40 |
|
Distance of spindle center to table |
100mm-490mm |
|
Distance from spindle center to overarm |
124mm |
|
MOTORS |
|
|
Horizontal spindle |
7.5HP4P |
|
Table longitudinal feed |
Oil Cylinder |
|
Column up-down |
1HP (Redicing Motor) |
|
Coolant pump |
1/8HP |
|
Net weight |
2200-2500Kg |
|
Packing Measurement (Seaworthy wooden case) |
1660x1790x1960mm |
|
※ There will be some changes for the specification and the design from time to time without any prior notice. |
|
|
STANDARD ACCESSORIES:
|
|
